Instrotech

Tel: +27 10 595 1831
Email: [email protected]
www: www.instrotech.co.za
more information about Instrotech

Load cell technology in practice - Conclusion
October 2002, System Integration & Control Systems Design

A lightning strike within a 300 m radius of the geometrical centre of the site will definitely have a detrimental effect on the weighbridge
read more


Load cells with digital outputs
October 2002, Maintenance, Test & Measurement, Calibration

Instrotech's range of Revere stainless steel compression and beam load cells are now available with digital output. The RS485 I RS422 bus allows the scada or DCS to communicate directly with each load ...
read more


Load cell technology in practice - Part IV
September 2002, System Integration & Control Systems Design

The installation of load cells into a practical field application requires careful attention if the system is to be safe and accurate
read more


Electronic pressure switches
September 2002, Pressure Measurement & Control

Available from Instrotech, Kobold pressure switches are appropriate where high switching accuracy, long-term stability and repeatability, on pressure monitoring is required. Switching ranges are from ...
read more


Load cell technology in practice - Part III
August 2002, System Integration & Control Systems Design

Besides a given IP-rating or NEMA-classification, load cells should also be classified according to their design in terms of cable entry, material of construction and gauges sealing method
read more


Handheld manometer featuring high accuracies
August 2002, Pressure Measurement & Control

The Blue Line series of digital handheld manometers have been designed to provide high accuracy measurements of pressure, vacuum and differential pressure gases. Instrotech supplies this Afriso unit ...
read more


Load cell technology in practice - Part II: Capacity selection and accuracy
July 2002, System Integration & Control Systems Design

Capacity selection requires a fundamental understanding of the load related terms for load cells as well as the load related factors associated with systems
read more


Load cell technology in practice - Part I
June 2002, System Integration & Control Systems Design

Load cells are designed to sense force or weight under a wide range of adverse conditions; they are not only the most essential part of an electronic weighing system, but also the most vulnerable
read more


Handheld flue gas analyser
June 2002, Analytical Instrumentation & Environmental Monitoring

Afriso has introduced a new flue gas analysis computer with draught measurement, which is marketed locally by Instrotech. The Eurolyzer is a handheld digital display analyser with state-of-the-art microprocessor ...
read more


SA-designed tube leak detection system
April 2002, Maintenance, Test & Measurement, Calibration

South African company, Instrotech, is currently processing nine new orders for its locally designed and manufactured tube leak detection systems, the Inspecta FFT, destined for power stations both locally ...
read more


Intelligent transmitter with digital indication
February 2002, Pressure Measurement & Control

The Leo 3 is a digital pressure indicator designed for permanent installation. It is a combination 2 wire 4-20 mA transmitter with programmable dual local indication of pressure in selectable units: (bar, ...
read more


Loadcells for Iscor's heavy minerals
October 2001, Maintenance, Test & Measurement, Calibration

Iscor's experience with Revere loadcells proving accurate and reliable on various weighing applications resulted in the company specifying them for the Richards Bay Heavy Minerals plant. Some 200 loadcells ...
read more





<< First   < Previous   Page 36 of 38   Next >   Last >>







While every effort has been made to ensure the accuracy of the information contained herein, the publisher and its agents cannot be held responsible for any errors contained, or any loss incurred as a result. Articles published do not necessarily reflect the views of the publishers. The editor reserves the right to alter or cut copy. Articles submitted are deemed to have been cleared for publication. Advertisements and company contact details are published as provided by the advertiser. Technews Publishing (Pty) Ltd cannot be held responsible for the accuracy or veracity of supplied material.




© Technews Publishing (Pty) Ltd | All Rights Reserved