Supplies for hazardous areas
November 2010
Electrical Power & Protection
Wago’s new 750-606 supply module has been awarded IEC Ex-i certification. The module delivers 1 A of current allowing it to supply more Ex-i I/O modules than the standard 750-625 module. It also separates the intrinsically safe from the non-intrinsically safe section of the Wago-I/O system and monitors power supply to the downstream Ex-i segment. The output circuit is equipped with an electronic fuse that automatically re-activates the output voltage 10s after the fault has been rectified when the fuse has tripped. The new Ex-i feed-in has a diagnosis function and signals, for example, when there is no input voltage present, or when the fuse has tripped.
Also certified for hazardous areas is the two-channel 750-487/003-000 analogue input module. This module registers temperature levels from zones 0 and 1 directly in the Wago I/O system that is installed in zone 2, or in a non-hazardous area. The Ex-i I/O module can accommodate up to two thermocouples (Model B, E, J, K, L, N, R, S, T, U) or voltage sensors (±30, ±60, ±120 mV) and performs linearisation over the entire temperature range.
The operating mode is parameterised using the Wago software. Cold junction compensation is utilised for the clamping unit offset voltage over the 0 to 55°C operating range. Status indicators signal operational readiness and violation of range limits. Field and system levels are electrically isolated. The 24 V supply is derived from the module’s power jumper contacts.
For more information contact Chris Huxham, Shorrock Automation, +27 (0)12 345 4449, [email protected], www.shorrock.co.za
Further reading:
Africa’s net-zero ambition must become operational
Schneider Electric South Africa
Electrical Power & Protection
Schneider Electric’s Rohit Chashta argues that the biggest gap in Africa’s green transition is not ambition but execution, and outlines how advisory services, bankable project roadmaps, digital visibility and SF6-free switchgear can turn sustainability commitments into measurable progress.
Read more...
High-efficiency half-brick DC-DC converters
Vepac Electronics
Electrical Power & Protection
The Supreme series half-brick DC-DC converters from Vepac Electronics use synchronous rectification for high conversion efficiency, in a six-sided metal case built to withstand harsh industrial and transportation environments.
Read more...
Zinc-based batteries power a more sustainable energy future
Electrical Power & Protection
Zinc-based batteries are gaining ground as a safe, recyclable and cost-effective energy storage option, from consumer electronics to grid-scale systems. The International Zinc Association’s Simon Norton explains why zinc is well placed to support the clean energy transition.
Read more...
Energas introduces lower-cost German gas genset for South African market
Electrical Power & Protection
Energas Technologies will supply R Schmitt Enertec’s new Energy Line genset to the South African market, offering German-engineered gas-to-power generation of 400 to 500 kW at a lower entry cost through focused standardisation and a simpler standalone architecture.
Read more...
ACTOM plays key role in large transmission substation project in Swellendam
ACTOM Electrical Machines
Electrical Power & Protection
ACTOM has been appointed to engineer, procure, construct and commission the 1000 MVA main transmission substation for the Overberg Wind Farm in Swellendam, one of the largest substations of its kind in South Africa.
Read more...
Reliable power conversion from high-voltage DC buses
Conical Technologies
Electrical Power & Protection
The MEAN WELL DDRH-240 from Conical Technologies is a high-reliability DIN-rail DC-DC converter with a wide 250 to 1500 V DC input range, deriving stable low-voltage power directly from high-voltage DC buses in renewable energy, storage, charging, railway and industrial installations.
Read more...
AES maintains a strong value and safety stance on boiler retrofits
Electrical Power & Protection
AES Commercial Director Dennis Williams explains when a boiler retrofit makes more sense than replacement, outlines the range of efficiency and emissions upgrades available, and draws the line at safety: a boiler not legally signed off is shut down, no exceptions.
Read more...
The grid needs to become more intelligent
Schneider Electric South Africa
Electrical Power & Protection
South Africa’s power grid is becoming bidirectional and far more dynamic as distributed energy resources proliferate. Schneider Electric’s Nishandra Bajinath explains why digitalisation, DERMS and aggregation are essential to keep this increasingly complex grid stable and efficient.
Read more...
ACTOM’s integrated electrical solutions reduce project risk and accelerate delivery
Electrical Power & Protection
ACTOM has secured multiple orders across four divisions for the Naos-1 hybrid solar and battery project in the Free State, demonstrating its integrated model for supplying the full electrical chain from high-voltage equipment to distribution transformers.
Read more...
Smarter energy management starts with intelligent electrification
ABB South Africa ABB Electrification Products
Electrical Power & Protection
ABB Electrification specialists Adeline Maleka and Nokulunga Dube explain how the convergence of electrification, digitalisation and automation is helping South African industries gain real-time visibility, reduce energy waste and build operational resilience.
Read more...
printer friendly version