Automatic power factor correction systems from AC/DC Dynamics
April 2013
Electrical Power & Protection
With the growing demand in the area of energy management and monitoring, the VMP and VMPC PFC ranges from AC/DC Dynamics feature 3 phase monitoring and both single and 3 phase compensation. This gives users the ability to determine precise compensation. On the technical side, 3 C/Ts are required to be installed with this monitoring system for accurate compensation and measurement. The VMPC range is supplied standard with a GEM-10, Ethernet, Modbus and GPRS gateway to address any communication interface requirements.
The Entes RGS-12 controller measures active energy (kWh), reactive energy (kVArh) and has energy ratio alarms. It measures and displays THDI, THDV (total harmonic distortion) for current and voltage with adjustable THDV alarm levels. Despite all the extra functions the controller is easy to set up, requiring no extra programming in auto setup mode.
The company has also launched a Web page where all parameters, measurements and alarms are recorded and monitored. The new software can be custom made to suite personal requirements. Monthly utility consumption, bills and various other power quality reports can be generated with ease, assisting management of the incoming supply quality, consumption and PFC unit.
The cabinet design provides top and bottom cable entry for easy installation and modularity allows for quick and easy configuration. If extra compensation is required, the system allows for extra racks or higher kVAr racks to be installed. The unique modular cabinets can be bolted up against each other in the event that the load demand increases. All that’s required is interconnection and adjustments to the controller’s set points. The design further incorporates MCC rack design, which utilises superior plug-in connectors.
The adjustable temperature controlled cooling fan’s location and ventilation design, extracts the air across the capacitors and contactors thus assisting with the heat transfer out of the cabinet.
Further reading:
High-efficiency half-brick DC-DC converters
Vepac Electronics
Electrical Power & Protection
The Supreme series half-brick DC-DC converters from Vepac Electronics use synchronous rectification for high conversion efficiency, in a six-sided metal case built to withstand harsh industrial and transportation environments.
Read more...
Zinc-based batteries power a more sustainable energy future
Electrical Power & Protection
Zinc-based batteries are gaining ground as a safe, recyclable and cost-effective energy storage option, from consumer electronics to grid-scale systems. The International Zinc Association’s Simon Norton explains why zinc is well placed to support the clean energy transition.
Read more...
Energas introduces lower-cost German gas genset for South African market
Electrical Power & Protection
Energas Technologies will supply R Schmitt Enertec’s new Energy Line genset to the South African market, offering German-engineered gas-to-power generation of 400 to 500 kW at a lower entry cost through focused standardisation and a simpler standalone architecture.
Read more...
ACTOM plays key role in large transmission substation project in Swellendam
ACTOM Electrical Machines
Electrical Power & Protection
ACTOM has been appointed to engineer, procure, construct and commission the 1000 MVA main transmission substation for the Overberg Wind Farm in Swellendam, one of the largest substations of its kind in South Africa.
Read more...
Reliable power conversion from high-voltage DC buses
Conical Technologies
Electrical Power & Protection
The MEAN WELL DDRH-240 from Conical Technologies is a high-reliability DIN-rail DC-DC converter with a wide 250 to 1500 V DC input range, deriving stable low-voltage power directly from high-voltage DC buses in renewable energy, storage, charging, railway and industrial installations.
Read more...
AES maintains a strong value and safety stance on boiler retrofits
Electrical Power & Protection
AES Commercial Director Dennis Williams explains when a boiler retrofit makes more sense than replacement, outlines the range of efficiency and emissions upgrades available, and draws the line at safety: a boiler not legally signed off is shut down, no exceptions.
Read more...
The grid needs to become more intelligent
Schneider Electric South Africa
Electrical Power & Protection
South Africa’s power grid is becoming bidirectional and far more dynamic as distributed energy resources proliferate. Schneider Electric’s Nishandra Bajinath explains why digitalisation, DERMS and aggregation are essential to keep this increasingly complex grid stable and efficient.
Read more...
ACTOM’s integrated electrical solutions reduce project risk and accelerate delivery
Electrical Power & Protection
ACTOM has secured multiple orders across four divisions for the Naos-1 hybrid solar and battery project in the Free State, demonstrating its integrated model for supplying the full electrical chain from high-voltage equipment to distribution transformers.
Read more...
Smarter energy management starts with intelligent electrification
ABB South Africa ABB Electrification Products
Electrical Power & Protection
ABB Electrification specialists Adeline Maleka and Nokulunga Dube explain how the convergence of electrification, digitalisation and automation is helping South African industries gain real-time visibility, reduce energy waste and build operational resilience.
Read more...
Electricity security is a strategic imperative for Africa’s growth and industrial future
Electrical Power & Protection
Grid resilience has become as strategic a priority as generation capacity. Africa needs robust transmission and distribution networks, skilled engineers and resilient supply chains to power its energy transition.
Read more...
printer friendly version